Service Manual

Task Command Syntax Command Mode
NOTE: You can also have the
management route to point to a
front-end port in case of the
management VRF. For example:
management route 2::/64 te 0/0.
To congure a static entry in the IPv6 neighbor discovery, perform the following steps:
Task Command Syntax Command Mode
Congure a static neighbor.
ipv6 neighbor vrf management
1::1 gigabitethernet 1/1
xx:xx:xx:xx:xx:xx
CONFIGURATION
Sample VRF Conguration
The following conguration illustrates a typical VRF set-up.
Figure 125. Setup OSPF and Static Routes
Virtual Routing and Forwarding (VRF)
853