Service Manual

Interface
Name Role PortID Prio Cost Sts Cost Link-type Edge
---------- ------ -------- ---- ------- ----------- ------- --------- ----
Po 1 Desg 128.2 128 188 FWD 0 (vltI)P2P No
Po 2 Desg 128.3 128 2000 FWD 0
(vlt) P2P No
Gi 1/10 Desg 128.230 128 2000 FWD 0 P2P Yes
Gi 1/13 Desg 128.233 128 2000 FWD 0 P2P No
Dell#
eVLT Conguration Example
The following example demonstrates the steps to congure enhanced VLT (eVLT) in a network.
In this example, you are conguring two domains. Domain 1 consists of Peer 1 and Peer 2; Domain 2 consists of Peer 3 and Peer 4, as
shown in the following example.
In Domain 1, congure Peer 1 st, then congure Peer 2. When that is complete, perform the same steps for the peer nodes in
Domain 2. The interface used in this example is TenGigabitEthernet.
Figure 123. eVLT Conguration Example
eVLT Conguration Step Examples
In Domain 1, congure the VLT domain and VLTi on Peer 1.
Domain_1_Peer1#configure
Domain_1_Peer1(conf)#interface port-channel 1
Domain_1_Peer1(conf-if-po-1)# channel-member GigabitEthernet 1/8-9
Domain_1_Peer1(conf)#vlt domain 1000
Domain_1_Peer1(conf-vlt-domain)# peer-link port-channel 1
Domain_1_Peer1(conf-vlt-domain)# back-up destination 10.16.130.11
Domain_1_Peer1(conf-vlt-domain)# system-mac mac-address 00:0a:00:0a:00:0a
Domain_1_Peer1(conf-vlt-domain)# unit-id 0
Congure eVLT on Peer 1.
Domain_1_Peer1(conf)#interface port-channel 100
Domain_1_Peer1(conf-if-po-100)# switchport
Domain_1_Peer1(conf-if-po-100)# vlt-peer-lag port-channel 100
Domain_1_Peer1(conf-if-po-100)# no shutdown
820
Virtual Link Trunking (VLT)