Service Manual

CONFIGURATION mode
interface managementethernet slot/ port
Enter the slot (0-1) and the port (0).
2. Congure an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) and mask (/x) on the interface.
MANAGEMENT INTERFACE mode
{ip address ipv4-address/ mask | ipv6 address ipv6-address/ mask}
This is the IP address to be congured on the VLT peer with the back-up destination command.
3. Ensure that the interface is active.
MANAGEMENT INTERFACE mode
no shutdown
4. Congure a VLT backup link using the IPv4 or IPv6 address of the VLT peer’s management interface.
MANAGEMENT INTERFACE mode
back-up destination {ip address ipv4-address/ mask | ipv6 address ipv6-address/ mask}
5. Repeat Steps 1 to 4 on the VLT peer switch.
To set an amount of time, in seconds, to delay the system from restoring the VLT port, use the delay-restore command at any
time. For more information, refer to
VLT Port Delayed Restoration.
Conguring a VLT Port Delay Period
To congure a VLT port delay period, use the following commands.
1. Enter VLT-domain conguration mode for a specied VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs from 1 to 1000.
2. Enter an amount of time, in seconds, to delay the restoration of the VLT ports after the system is rebooted.
CONFIGURATION mode
delay-restore delay-restore-time
The range is from 1 to 1200.
The default is 90 seconds.
Reconguring the Default VLT Settings (Optional)
To recongure the default VLT settings, use the following commands.
1. Enter VLT-domain conguration mode for a specied VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
2. (Optional) After you congure the VLT domain on each peer switch on both sides of the interconnect trunk, by default, Dell
Networking OS elects a primary and secondary VLT peer device.
VLT DOMAIN CONFIGURATION mode
Virtual Link Trunking (VLT)
811