Service Manual

• You must have at least one link connection to each unit of the VLT domain.
Following are the prerequisites for Proxy Gateway LLDP conguration:
• You must globally enable LLDP.
• You cannot have interface–level LLDP disable commands on the interfaces congured for proxy gateway and you must enable
both transmission and reception.
• You must connect both units of the remote VLT domain by the port channel member.
• If you connect more than one port to a unit of the remote VLT domain, the connection must be completed by the time you
enable the proxy gateway LLDP.
• You cannot have other conicting congurations (for example, you cannot have a static proxy gateway conguration).
Proxy Gateway LLDP conguration might not operate properly if one of the following conditions is true:
• Any proxy gateway conguration or LLDP conguration is not working.
• LLDP packets fail to reach the remote VLT domain devices (for example, because the system is down, rebooting, or the port
physical link connection is down).
Sample Conguration for a VLT Proxy Gateway
VLT Proxy Gateway
793