Service Manual

As shown in the following illustration (STP topology 2, upper right), a loop can also be created if the forwarding port on Switch B
becomes busy and does not forward BPDUs within the congured forward-delay time. As a result, the blocking port on Switch
C transitions to a forwarding state, and both Switch A and Switch C transmit trac to Switch B (STP topology 2, lower right).
As shown in STP topology 3 (bottom middle), after you enable loop guard on an STP port or port-channel on Switch C, if no BPDUs
are received and the max-age timer expires, the port transitions from a blocked state to a Loop-Inconsistent state (instead of to a
Forwarding state). Loop guard blocks the STP port so that no trac is transmitted and no loop is created.
As soon as a BPDU is received on an STP port in a Loop-Inconsistent state, the port returns to a blocking state. If you disable STP
loop guard on a port in a Loop-Inconsistent state, the port transitions to an STP blocking state and restarts the max-age timer.
Figure 115. STP Loop Guard Prevents Forwarding Loops
Conguring Loop Guard
Enable STP loop guard on a per-port or per-port channel basis.
Dell Networking OS Behavior: The following conditions apply to a port enabled with loop guard:
• Loop guard is supported on any STP-enabled port or port-channel interface.
• Loop guard is supported on a port or port-channel in any spanning tree mode:
Spanning Tree Protocol (STP)
759