Service Manual

Transactions between the RADIUS server and the client are encrypted (the users’ passwords are not sent in plain text). RADIUS
uses UDP as the transport protocol between the RADIUS server host and the client.
For more information about RADIUS, refer to RFC 2865, Remote Authentication Dial-in User Service.
RADIUS Authentication
Dell Networking OS supports RADIUS for user authentication (text password) at login and can be specied as one of the login
authentication methods in the
aaa authentication login command.
Idle Time
Every session line has its own idle-time. If the idle-time value is not changed, the default value of 30 minutes is used.
RADIUS species idle-time allow for a user during a session before timeout. When a user logs in, the lower of the two idle-time
values (congured or default) is used. The idle-time value is updated if both of the following happens:
• The administrator changes the idle-time of the line on which the user has logged in.
• The idle-time is lower than the RADIUS-returned idle-time.
ACL Conguration Information
The RADIUS server can specify an ACL. If an ACL is congured on the RADIUS server, and if that ACL is present, the user may be
allowed access based on that ACL.
If the ACL is absent, authorization fails, and a message is logged indicating this.
RADIUS can specify an ACL for the user if both of the following are true:
• If an ACL is absent.
• If there is a very long delay for an entry, or a denied entry because of an ACL, and a message is logged.
NOTE: The ACL name must be a string. Only standard ACLs in authorization (both RADIUS and TACACS) are supported.
Authorization is denied in cases using Extended ACLs.
Auto-Command
You can congure the system through the RADIUS server to automatically execute a command when you connect to a specic line.
The auto-command command is executed when the user is authenticated and before the prompt appears to the user.
• Automatically execute a command.
auto-command
Privilege Levels
Through the RADIUS server, you can congure a privilege level for the user to enter into when they connect to a session.
This value is congured on the client system.
• Set a privilege level.
privilege level
Conguration Task List for RADIUS
To authenticate users using RADIUS, you must specify at least one RADIUS server so that the system can communicate with and
congure RADIUS as one of your authentication methods.
The following list includes the conguration tasks for RADIUS.
• Dening a AAA Method List to be Used for RADIUS (mandatory)
• Applying the Method List to Terminal Lines (mandatory except when using default lists)
• Specifying a RADIUS Server Host (mandatory)
• Setting Global Communication Parameters for all RADIUS Server Hosts (optional)
652
Security