Service Manual

•
debug ip rip [interface | database | events | trigger]
EXEC privilege mode
Enable debugging of RIP.
Example of the debug ip rip Command
The following example shows the conrmation when you enable the debug function.
Dell#debug ip rip
RIP protocol debug is ON
Dell#
To disable RIP, use the no debug ip rip command.
RIP Conguration Example
The examples in this section show the command sequence to congure RIPv2 on the two routers shown in the following illustration
— Core 2 and Core 3.
The host prompts used in the following example reect those names. The examples are divided into the following groups of
command sequences:
• Conguring RIPv2 on Core 2
• Core 2 RIP Output
• RIP Conguration on Core 3
• Core 3 RIP Output
• RIP Conguration Summary
Figure 101. RIP Topology Example
RIP Conguration on Core2
The following example shows how to congure RIPv2 on a host named Core2.
Example of Conguring RIPv2 on Core 2
Core2(conf-if-gi-2/3)#
Core2(conf-if-gi-2/3)#router rip
Core2(conf-router_rip)#ver 2
Core2(conf-router_rip)#network 10.200.10.0
Core2(conf-router_rip)#network 10.300.10.0
Core2(conf-router_rip)#network 10.11.10.0
Core2(conf-router_rip)#network 10.11.20.0
Core2(conf-router_rip)#show config
!
router rip
network 10.0.0.0
version 2
Core2(conf-router_rip)#
Routing Information Protocol (RIP)
623