Service Manual

Default version control: receive version 2, send version 2
Interface Recv Send
GigabitEthernet 1/1 2 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
Dell#
To congure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The command syntax for
sending both RIPv1 and RIPv2 and receiving only RIPv2 is shown in the following example.
Dell(conf-if)#ip rip send version 1 2
Dell(conf-if)#ip rip receive version 2
The following example of the show ip protocols command conrms that both versions are sent out that interface. This
interface no longer sends and receives the same RIP versions as Dell Networking OS does globally (shown in bold).
Dell#show ip protocols
Routing Protocols is RIP
Sending updates every 30 seconds, next due in 11
Invalid after 180 seconds, hold down 180, flushed after 240
Output delay 8 milliseconds between packets
Automatic network summarization is in effect
Outgoing filter for all interfaces is
Incoming filter for all interfaces is
Default redistribution metric is 1
Default version control:
receive version 2, send version 2
Interface Recv Send
GigabitEthernet 1/1 2 1 2
Routing for Networks:
10.0.0.0
Routing Information Sources:
Gateway Distance Last Update
Distance: (default is 120)
Dell#
Generating a Default Route
Trac is forwarded to the default route when the trac’s network is not explicitly listed in the routing table.
Default routes are not enabled in RIP unless specied. Use the default-information originate command in ROUTER RIP
mode to generate a default route into RIP. In Dell Networking OS, default routes received in RIP updates from other routes are
advertised if you congure the default-information originate command.
• Specify the generation of a default route in RIP.
ROUTER RIP mode
default-information originate [always] [metric value] [route-map route-map-name]
– always: Enter the keyword always to always generate a default route.
– value The range is from 1 to 16.
– route-map-name: The name of a congured route map.
To conrm that the default route conguration is completed, use the show config command in ROUTER RIP mode.
Routing Information Protocol (RIP)
621