Service Manual

Honoring dot1p Values on Ingress Packets
Dell Networking OS honors dot1p values on ingress packets with the Trust dot1p feature.
The following table species the queue to which the classied trac is sent based on the dot1p value.
Table 47. Default dot1p to Queue Mapping
dot1p Queue ID
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Table 48. Default dot1p to Queue Mapping
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
The dot1p value is also honored for frames on the default VLAN. For more information, refer to Priority-Tagged Frames on the
Default VLAN.
• Enable the trust dot1p feature.
POLICY-MAP-IN mode
trust dot1p
Mapping dot1p Values to Service Queues
All trac is by default mapped to the same queue, Queue 0.
If you honor dot1p on ingress, you can create service classes based the queueing strategy in Honoring dot1p Values on Ingress
Packets. You may apply this queuing strategy globally by entering the following command from CONFIGURATION mode.
• All dot1p trac is mapped to Queue 0 unless you enable service-class dynamic dot1p on an interface or globally.
• Layer 2 or Layer 3 service policies supersede dot1p service classes.
• Create service classes.
INTERFACE mode
service-class dynamic dot1p
596
Quality of Service (QoS)