Service Manual

Applying a Privilege Level to a Terminal Line
To set a privilege level for a terminal line, use the following command.
• Congure a privilege level for a user.
CONFIGURATION mode
username username privilege level
NOTE: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode, but the prompt
is hostname#, rather than hostname>.
Conguring Logging
The Dell Networking OS tracks changes in the system using event and error messages.
By default, Dell Networking OS logs these messages on:
• the internal buer
• console and terminal lines
• any congured syslog servers
To disable logging, use the following commands.
• Disable all logging except on the console.
CONFIGURATION mode
no logging on
• Disable logging to the logging buer.
CONFIGURATION mode
no logging buffer
• Disable logging to terminal lines.
CONFIGURATION mode
no logging monitor
• Disable console logging.
CONFIGURATION mode
no logging console
Audit and Security Logs
This section describes how to congure, display, and clear audit and security logs.
The following is the conguration task list for audit and security logs:
• Enabling Audit and Security Logs
• Displaying Audit and Security Logs
• Clearing Audit Logs
Enabling Audit and Security Logs
You enable audit and security logs to monitor conguration changes or determine if these changes aect the operation of the
system in the network. You log audit and security events to a system log server, using the logging extended command in
CONFIGURATION mode.
This command is available with or without RBAC enabled. For information about RBAC, see Role-Based Access Control.
Management
59