Service Manual

The interface range prompt oers the interface (with slot and port information) for valid interfaces. The maximum size of an
interface range prompt is 32. If the prompt size exceeds this maximum, it displays (...) at the end of the output.
NOTE: Non-existing interfaces are excluded from the interface range prompt.
NOTE: When creating an interface range, interfaces appear in the order they were entered and are not sorted.
The show range command is available under Interface Range mode. This command allows you to display all interfaces that have
been validated under the interface range context.
The show configuration command is also available under Interface Range mode. This command allows you to display the
running conguration only for interfaces that are part of interface range.
Bulk Conguration Examples
Use the interface range command for bulk conguration.
• Create a Single-Range
• Create a Multiple-Range
• Exclude Duplicate Entries
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
• Add Ranges
Create a Single-Range
The following is an example of a single range.
Example of the interface range Command (Single Range)
Dell(config)# interface range tgigabitethernet 1/1 - 1/23
Dell(config-if-range-gi-1/1-1/23)# no shutdown
Dell(config-if-range-gi-1/1-1/23)#
Create a Multiple-Range
The following is an example of multiple range.
Example of the interface range Command (Multiple Ranges)
Dell(conf)#interface range gigabitethernet 1/5 - 1/10 , gigabitethernet 1/1 , vlan 1
Dell(conf-if-range-gi-1/1,gi-1/5-1/10,vl-1)#
Exclude Duplicate Entries
The following is an example showing how duplicate entries are omitted from the interface-range prompt.
Example of the Interface-Range Prompt for Duplicate Interfaces
Dell(conf)#interface range vlan 1 , vlan 1 , vlan 3 , vlan 3
Dell(conf-if-range-vl-1,vl-3)#
Dell(conf)#interface range gigabitethernet 2/1 - 23 , gigabitethernet 2/1 - 23 , gigab 2/1
- 23
Dell(conf-if-range-gi-2/1-23)#
Exclude a Smaller Port Range
The following is an example show how the smaller of two port ranges is omitted in the interface-range prompt.
Example of the Interface-Range Prompt for Multiple Port Ranges
Dell(conf)#interface range gigabitethernet 2/1 - 2/23 , gigab 2/1 - 2/10
Dell(conf-if-range-gi-2/1-2/23)#
Interfaces
319