Service Manual

• virtual-ip is a CONFIGURATION mode command.
• When applied, the management port on the primary RPM assumes the virtual IP address. Executing the show interfaces
and show ip interface brief commands on the primary RPM management interface displays the virtual IP address and
not the actual IP address assigned on that interface.
• A duplicate IP address message is printed for the management port’s virtual IP address on an RPM failover. This behavior is a
harmless error that is generated due to a brief transitory moment during failover when both RPMs’ management ports own the
virtual IP address, but have dierent MAC addresses.
• The primary management interface uses only the virtual IP address if it is congured. The system cannot be accessed through
the native IP address of the primary RPM’s management interface.
• After the virtual IP address is removed, the system is accessible through the native IP address of the primary RPM’s
management interface.
• Primary and secondary management interface IP and virtual IP must be in the same subnet.
To view the Primary RPM Management port, use the show interface Managementethernet command in EXEC Privilege
mode. If there are two RPMs, you cannot view information on that interface.
Conguring Management Interfaces on the S-Series
You can manage the S-Series from any port.
To congure an IP address for the port, use the following commands. There is no separate management routing table, so congure
all routes in the IP routing table (the
ip route command).
• Congure an IP address.
INTERFACE mode
ip address
• Enable the interface.
INTERFACE mode
no shutdown
• The interface is the management interface.
INTEFACE mode
description
Example of the show interface and show ip route Commands
To display the conguration for a given port, use the show interface command in EXEC Privilege mode, as shown in the
following example. To display the routing table, use the
show ip route command in EXEC Privilege mode.
Dell#show int gig 1/1
GigabitEthernet 1/1 is up, line protocol is up
Description: This is the Managment Interface
Hardware is Force10Eth, address is 00:01:e8:cc:cc:ce
Current address is 00:01:e8:cc:cc:ce
Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.241/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
Interfaces
309