Service Manual

• Sets weight for the route.
CONFIG-ROUTE-MAP mode
set weight weight
– weight: the range is from 0 to 65535.
To view BGP conguration, use the show config command in CONFIGURATION ROUTER BGP mode or the show running-
config bgp command in EXEC Privilege mode.
Enabling Multipath
By default, the software allows one path to a destination. You can enable multipath to allow up to 64 parallel paths to a destination.
NOTE: Dell Networking recommends not using multipath and add path simultaneously in a route reector.
To allow more than one path, use the following command.
The show ip bgp network command includes multipath information for that network.
• Enable multiple parallel paths.
CONFIG-ROUTER-BGP mode
maximum-paths {ebgp | ibgp} number
Filtering BGP Routes
Filtering routes allows you to implement BGP policies.
You can use either IP prex lists, route maps, AS-PATH ACLs or IP community lists (using a route map) to control which routes the
BGP neighbor or peer group accepts and advertises. Prex lists lter routes based on route and prex length, while AS-Path ACLs
lter routes based on the ASN. Route maps can lter and set conditions, change attributes, and assign update policies.
NOTE: Dell Networking OS supports up to 255 characters in a set community statement inside a route map.
NOTE: With Dell Networking OS, you can create inbound and outbound policies. Each of the commands used for ltering
has in and out parameters that you must apply. In Dell Networking OS, the order of preference varies depending on
whether the attributes are applied for inbound updates or outbound updates.
For inbound and outbound updates the order of preference is:
• prex lists (using the neighbor distribute-list command)
• AS-PATH ACLs (using the neighbor filter-list command)
• route maps (using the neighbor route-map command)
Prior to ltering BGP routes, create the prex list, AS-PATH ACL, or route map.
For conguration information about prex lists, AS-PATH ACLs, and route maps, refer to Access Control Lists (ACLs).
NOTE: When you congure a new set of BGP policies, to ensure the changes are made, always reset the neighbor or
peer group by using the clear ip bgp command in EXEC Privilege mode.
To lter routes using prex lists, use the following commands.
1. Create a prex list and assign it a name.
CONFIGURATION mode
ip prefix-list prefix-name
2. Create multiple prex list lters with a deny or permit action.
CONFIG-PREFIX LIST mode
seq sequence-number {deny | permit} {any | ip-prefix [ge | le] }
Border Gateway Protocol IPv4 (BGPv4)
201