Reference Guide

Supported Releases 10.2.0E or later
interface vlan
Creates a VLAN interface.
Syntax
interface vlan vlan-id
Parameters vlan-id — Enter the VLAN ID number (1 to 4093).
Default VLAN 1
Command Mode CONFIGURATION
Usage Information FTP, TFTP, MAC ACLs, and SNMP operations are not supported — IP ACLs are supported on VLANs only. The no
version of this command deletes the interface.
Example
OS10(config)# interface vlan 10
OS10(conf-if-vl-10)#
Supported Releases 10.2.0E or later
link-bundle-utilization
Congures link-bundle utilization.
Syntax
link-bundle-utilization trigger-threshold value
Parameters value — Enter the percentage of port-channel bandwidth that triggers trac monitoring on port-channel
members (0 to 100).
Default Disabled
Command Mode CONFIGURATION
Usage Information None
Example
OS10(config)# link-bundle-utilization trigger-threshold 10
Supported Releases 10.2.0E or later
mode
Congures a front-panel unied port group to operate in Fibre Channel or Ethernet mode, or a QSFP28-DD port to operate in Ethernet
mode, with the specied speed on activated interfaces.
Syntax
mode {Eth {100g-2x | 100g-1x | 50g-2x | 40g-2x | 40g-1x | 25g-8x [fabric-
expander-mode] | 25g-4x | 10g-8x | 10g-4x} | FC {32g-2x | 32g-1x | 16g-4x |
16g-2x |8g-4x}}
Parameters
• mode Eth — Congure a port group in Ethernet mode and set the speed to:
– 100g-2x — Split a QSFP28-DD port into two 100GE interfaces.
– 100g-1x — Reset a QSFP28 port group to 100GE mode.
– 50g-2x — Split a QSFP28 port into two 50GE interfaces.
Interfaces 105