Install Guide
Table Of Contents
- S3048-ON Installation Guide January 2019
- About this guide
- The S3048–ON switch
- Site preparations
- NEBS compliance
- Install the S3048–ON
- Power supplies
- Fans
- Management ports
- Specifications
- Chassis physical design
- IEEE Standards
- Agency compliance
- USA Federal Communications Commission Statement
- European Union EMC Directive Conformance Statement
- Japan VCCI Compliance for Class A Equipment
- Korean Certification of Compliance
- Safety Standards and Compliance Agency Certifications
- Electromagnetic compatibility
- Product recycling and disposal
- Dell EMC support
Specications
This chapter lists the S3048–ON specications.
CAUTION: Operate the product at an ambient temperature not higher than 113°F (45°C).
CAUTION: Lithium Battery Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace only with same
or equivalent type of battery. Dispose of the batteries according to the manufacturer's instructions.
NOTE: For RoHS information, see Restricted Material Compliance.
Topics:
• Chassis physical design
• IEEE Standards
• Agency compliance
• USA Federal Communications Commission Statement
• European Union EMC Directive Conformance Statement
• Japan VCCI Compliance for Class A Equipment
• Korean Certication of Compliance
• Safety Standards and Compliance Agency Certications
• Electromagnetic compatibility
• Product recycling and disposal
Chassis physical design
Table 4. Chassis physical design
Parameter Specications
Height 1.73 inches (44 mm)
Width 17.09 inches (434 mm)
Depth 12.60inches (320 mm)
Chassis Weight with Factory-Installed Components
6.55kg (2*PSUs)
5.65kg (1*PSU)
Rack Clearance Required
Front: 5 inches (12.7 cm)
Rear: 5 inches (12.7 cm)
Table 5. Environmental parameters
Parameter Specications
Operating Temperature 32° to 113°F (0° to 45°C)
Operating Humidity 5 to 85% (RH), non-condensing
9
Specications 33