Administrator Guide

Gi 1/8 Up 1000 Mbit Auto 1502,1504,1506-1508,1602
Gi 1/9 Down Auto Auto --
Gi 1/10 Down Auto Auto --
Gi 1/11 Down Auto Auto --
Gi 1/12 Down Auto Auto --
Gi 1/13 Down Auto Auto --
Gi 1/14 Down Auto Auto --
Gi 1/15 Down Auto Auto --
Gi 1/16 Down Auto Auto -DellEMC#
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag status
and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• For physical interfaces, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports as port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces port—channel 1 - 4.
stack-unit unit-id (OPTIONAL) Enter the keywords stack-unit then the stack member number.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
642 Interfaces