Administrator Guide

0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 1 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions
Rate info (interval 299 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Time since last interface status change: 00:04:59
DellEMC#
show interfaces dampening
Display interface dampening information.
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
interface (Optional) Enter one of the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the
notation for specifying port range in the command is different from how you
specify in non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
summary (OPTIONAL) Enter the keyword summary to display the current summary of dampening
data, including the number of interfaces configured and the number of interfaces
suppressed, if any.
detail (OPTIONAL) Enter the keyword detail to display detailed interface dampening data.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.9(0.0) Added support to display the interface configurations corresponding to a range of ports.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
Interfaces 635