Administrator Guide

• interface loopback — configure a Loopback interface.
• interface port-channel — configure a port channel.
• interface vlan — configure a VLAN.
• ip unreachables — enable generation of internet control message protocol (ICMP) unreachable messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are applied (bulk configuration). Using the
interface range command, you can enter identical commands for a range of interface.
Syntax
interface range interface {slot/port | port} — {slot/port | port}, interface
{slot/port | port} — {slot/port | port},...
Parameters
interface {slot/
port | port} —
{slot/port | port},
interface {slot/
port | port} —
{slot/port |
port},...
Enter interface range and one of the interfaces and then the interface information.
Select the range of interfaces for bulk configuration. You can enter up to six comma-
separated ranges. Spaces are not required between the commas. The ranges can include
VLANs, port-channels, and physical interfaces.
• For a port channel interface, enter the keywords port-channel then a number.
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Tunnel interface, enter the keyword Tunnel then a number from 1 to 16383.
Defaults None
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Updated the error message when no ports are configured within the specified interface
range.
9.13(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P2) Introduced on the S4038-ON.
9.8(0.0P5) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
Interfaces 607