Administrator Guide

Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series and S-Series.
host-address
For manual (rather than automatic) configurations, assign a host to a single-address pool.
Syntax
host—address address
Parameters
address Enter the host IP address.
Defaults None
Command Modes DHCP-POOL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14.1.3 This command replaces host command. Introduced on S3048–ON, S4048–ON,
S4048T-ON, S6000–ON, S6010–ON, S6100–ON, Z9100–ON, S3100, S6000, S4810,
S4820T, S5048F-ON, MXL, FN-IOM, and C9010.
Usage Information
When you upgrade the Dell EMC Networking OS from an earlier version to 9.14.1.3 or later, the system converts
the DHCP CONFIGURATION host command in the running configuration to the host-address command. If
you downgrade the Dell EMC Networking OS from version 9.14.1.3 or later to an earlier version, any existing
host-address command is deleted from the running configuration. If you want to create manual DHCP
bindings, use the
host command.
ip dhcp server
Enable DHCP server globally.
Syntax
[no] ip dhcp server
To disable the DHCP server, use the no ip dhcp server command.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
492 Dynamic Host Configuration Protocol (DHCP)