Administrator Guide

• lt (less than) — matches packets that contain a ttl value that is less than the
specified ttl value.
• range(inclusive range of values) — matches packets that contain a ttl value that
falls between the specified range of ttl values.
count (OPTIONAL) Enter the keyword count to count the packets.
bytes (OPTIONAL) Enter the keyword bytes to count the bytes.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
dscp (OPTIONAL) Enter the keyword dcsp to match to the IP DSCP values. The range is from
0 to 63.
ecn (OPTIONAL) Enter the keyword ecn to match to the ECN values. The range is from 0 to
3.
order (OPTIONAL) Enter the keyword order to specify the QoS order for the ACL entry. The
range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the keyword order, the ACLs have the
lowest order by default (255).
monitor (OPTIONAL) Enter the keyword monitor then the session–ID to describe the traffic
that you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. The session–ID range is from 0 to 65535.
NOTE: For more information, see “Flow-based Monitoring” in the Port
Monitoring section of the Dell EMC Networking OS Configuration Guide .
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the ttl parameter.
9.11(2.0P0) Included support for using logical names of a protocol to configure an IP access list in both
TCP and UDP on the S6000, S6000–ON, S6100–ON, Z9100–ON.
9.11(0.0) Added support for session–ID to the monitor parameter.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
212 Access Control Lists (ACL)