Administrator Guide

Routing Information Protocol (RIP)
Routing information protocol (RIP) is a distance vector routing protocol. The Dell EMC Networking OS supports both RIP version 1
(RIPv1) and RIP version 2 (RIPv2).
The Dell EMC Networking OS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information about configuring
RIP, see the Dell EMC Networking OS Configuration Guide.
Topics:
• auto-summary
• clear ip rip
• debug ip rip
• default-information originate
• default-metric
• description
• distance
• distribute-list in
• distribute-list out
• ip poison-reverse
• ip rip receive version
• ip rip send version
• ip split-horizon
• maximum-paths
• neighbor
• network
• offset-list
• output-delay
• passive-interface
• redistribute
• redistribute isis
• redistribute ospf
• router rip
• show config
• show ip rip database
• show running-config rip
• timers basic
• version
auto-summary
Restore the default behavior of automatic summarization of subnet routes into network routes. This command applies only to RIP version
2.
Syntax
auto-summary
To send sub-prefix routing information, use the no auto-summary command.
Defaults Enabled.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
44
1232 Routing Information Protocol (RIP)