Administrator Guide

ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
To return to the default setting, use the no ip tftp source-interface interface command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
•
For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards.
8.2.1.0 Increased number of VLANs to 4094 (was 2094).
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
ip tftp vrf
Configures an TFTP client with a VRF that is used to connect to the TFTP server.
Syntax
ip tftp [vrf vrf-name]
To undo the TFTP client configuration, use the no ip tftp [vrf vrf-name] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to specify the VRF that is used by
the TFTP client.
108 Control and Monitoring