Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1021

• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the

slot/port information.

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the slot/port information.

• For a VLAN, enter the keyword vlan then a number from 1 to 4094.

Command Modes ROUTER OSPF

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

7.4.1.0 Modified to include the keyword default.

pre- 6.1.1.1 Introduced on the E-Series.

Usage Information

Although the passive interface does not send or receive routing updates, the network on that interface is still

included in OSPF updates sent using other interfaces.

The default keyword sets all interfaces as passive. You can then configure individual interfaces, where

adjacencies are desired, using the no passive-interface interface command. The no form of this

command is inserted into the configuration for individual interfaces when the no passive-interface

interface command is issued while passive-interface default is configured.

This command behavior has changed as follows:

passive-interface interface

•

The previous no passive-interface interface is removed from the running configuration.

• The ABR status for the router is updated.

• Save passive-interface interface into the running configuration.

passive-interface default

• All present and future OSPF interfaces are marked as passive.

• Any adjacency is explicitly terminated from all OSPF interfaces.

• All previous passive-interface interface commands are removed from the running configuration.

• All previous no passive-interface interface commands are removed from the running

configuration.

Open Shortest Path First (OSPFv2 and OSPFv3) 1027