Administrator Guide

0 39 36 37 37 31 31 46
show inventory
Display the switch type, components (including media), and Dell Networking Operating System (OS), including hardware identication
numbers and congured protocols.
Syntax
show inventory [media slot]
Parameters
media slot (OPTIONAL) Enter the keyword media then the stack ID of the stack member for which
you want to display pluggable media inventory.
NOTE: This parameter is available but not supported in Dell Networking
Operating System version 8.3.11.4. Because stacking is not supported, if you
use this parameter, the output displays “Media not present or accessible”
(refer to the Usage Information section).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Added support to display 10GBASE-T information on the S4048, S4048T, S6000, S6000-
ON, S6100, Z9500, S6010, and Z9100.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.4 Output expanded to include Piece Part ID (PPID) and eSR4 optics.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced this version of the command for S-Series. S-Series output diers from E-
Series.
Usage Information
If there are no ber ports in the unit, just the header under show inventory media displays. If there are ber ports
but no optics inserted, the output displays Media not present or accessible.
Control and Monitoring 133