Users Guide
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 F10 Monitoring MIB available for the ip traffic statistics command.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip traffic summary shown in the following example.
Keyword Denition
unknown protocol... No receiver for these packets. Counts packets whose protocol type eld is not recognized
by Dell Networking OS.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets that could not be forwarded
due to:
• route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
• destination IP address belongs to reserved prexes; the host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t fragment Number of packets that could not be fragmented and forwarded.
790 IPv4 Routing