Users Guide
Version Description
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
Usage Information To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip max-routes
Enables you to congure the maximum number of protocol routes per VRF that are allowed for IPv4.
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for which you want to congure
maximum number of protocol routes that IPv4 allows.
max-number Enter the maximum number of protocol routes that a VRF RTM can hold. The range is
from 0 to 7500.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of protocol routes that the Route Table Manager can hold for a
specic VRF. This command does not apply to the management VRFs.
Related Commands
• show ip route — view the switch routing table.
• show ipv6 route — display the IPv6 routes.
754 IPv4 Routing