Users Guide

Field Description
• In Layer 3 port channels, the primary port is not indicated.
Example
Dell# show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Gi 3/1 (Up) *
Gi 3/2 (Down)
Gi 3/3 (Up)
Dell#
Related Commands
• show lacp — display the LACP matrix.
show port-channel-ow
Display an egress port in a given port-channel ow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address {vlan
vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port channel
to display ow information.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to
128.
incoming-interface
interface
Enter the keywords incoming-interface then the interface type and the interface
information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
source-ip address Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP address
format.
source-port number Enter the keywords source-port then the source port number. The range is from 1 to
65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The range
is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the nn:nn:nn:nn:nn:nn
format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
Interfaces 709