Users Guide

If you congure the wavelength on a non-tunable optic, there is no change to the existing wavelength. The
congured wavelength is saved in the running conguration and is applicable, when a tunable optic is used.
If you do not congure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
Dell(conf-if-gi-1/1)# wavelength 1528.30
Related Commands
• show cong — displays the interface conguration.
Egress Interface Selection (EIS) Commands
The following commands are Egress Interface Selection (EIS) commands.
application
Congure the management egress interface selection.
Syntax
application {all | application-type}
To remove a management application conguration, use the no application {all | application-
type} command.
Parameters
application-type Enter any of the following keywords:
• For DNS, enter the keyword dns.
• For FTP, enter the keyword ftp.
• For NTP, enter the keyword ntp.
• For Radius, enter the keyword radius.
• For sFlow collectors, enter the keyword sflow-collector.
• For SNMP (traps and MIB responses), enter the keywords snmp .
• For SSH, enter the keyword ssh .
• For Syslog, enter the keyword syslog.
• For TACACS, enter the keyword tacacs.
• For Telnet, enter the keyword telnet.
• For TFTP, enter the keyword tftp.
all Congure all applications.
Defaults None.
Command Modes EIS Mode (conf-mgmt-eis)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Interfaces 695