Users Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced
Usage Information The output of the show interfaces command displays the congured rate interval, along with the collected
trac data.
rate-interval (Conguration Mode)
Congure the trac sampling interval for all physical and logical port-channel interfaces globally. The support to congure rate-interval
globally enables you to modify the default interval rate for all physical and logical interfaces at one time.
Syntax
rate-interval seconds
Use the no rate-interval command to remove the sampling interval conguration.
Parameters
seconds Enter the number of seconds for which to collect trac data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here round to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45. If you congure this value to be less than 5, then the
entire buer is cleared; the show int stats command shows the rate
information to be 0 as the polling interval is less than 5.
Defaults 299 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11.0.0 Introduced on all Dell Networking OS platforms.
Interfaces 657