Users Guide
owcontrol
Control how the system responds to and generates 802.3x pause ow control frames.
Syntax
flowcontrol {rx {off | on} tx {off | on} [negotiate | pause-threshold value |
resume-offset value] | [monitor session-ID]}
To return to the default, use the no form of this command.
Parameters
rx on Enter the keywords rx on to process the received ow control frames on this port.
NOTE: Flow-control packets are mirrored only when ow-control rx is
enabled on an interface.
rx o Enter the keywords rx off to ignore the received ow control frames on this port.
tx on Enter the keywords tx on to send control frames from this port to the connected device
when a higher rate of trac is received.
tx o Enter the keywords tx off so that ow control frames are not sent from this port to
the connected device when a higher rate of trac is received.
pause-threshold Enter the buer threshold limit for generating PAUSE frames.
resume-oset Enter the oset value for generating PAUSE frames to resume trac.
negotiate (Optional) Enter the keyword negotiate to enable the pause-negotiation with the
egress port of the peer device. If the negotiate command is not used, pause-
negotiation is disabled. 40-gigabit Ethernet interfaces do not support pause-negotiation
monitor Enter the keyword monitor then the session-ID to enable mirror ow control frames on
the interface. The range is from 0 to 65535.
Defaults rx on tx o
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Added support for monitor session.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
634 Interfaces