Users Guide

PREFIX-LIST Mode

To congure a prex list, use PREFIX-LIST mode.

To enter PREFIX-LIST mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the ip prefix-list command and the name for the prex list. The prompt changes to include conf-nprefixl.

You can return to CONFIGURATION mode by using the exit command.

PROTOCOL GVRP Mode

To enable and congure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, see GARP VLAN

Registration (GVRP).

To enter PROTOCOL GVRP mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol gvrp command. The prompt changes to include config-gvrp.

You can return to CONFIGURATION mode by using the exit command.

RAPID SPANNING TREE (RSTP) Mode

To enable and congure RSTP, use RSTP mode. For more information, see Rapid Spanning Tree Protocol (RSTP).

To enter RSTP mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Enter the protocol spanning-tree rstp command. The prompt changes to include conf-rstp.

You can return to CONFIGURATION mode by using the exit command.

ROUTE-MAP Mode

To congure a route map, use ROUTE-MAP mode.

To enter ROUTE-MAP mode:

1 Verify that you are logged in to CONFIGURATION mode.

2 Use the route-map map-name [permit | deny] [sequence-number] command. The prompt changes to include

config-route-map.

You can return to CONFIGURATION mode by using the exit command.

ROUTER BGP Mode

To enable and congure Border Gateway Protocol (BGP), use ROUTER BGP mode. For more information, see Border Gateway Protocol

IPv4 (BGPv4)

To enter ROUTER BGP mode:

CLI Basics