Users Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information At least one interface must be in Layer 3 mode for the router bgp command to be accepted. If all interfaces are
congured under VRF, at least one interface should be in the default VRF for the router
bgp
command to be accepted. If no interfaces are enabled for Layer 3, an error message appears:
% Error: No router id
configured
BGP does not allow 23456 (AS-TRANS) as a congured AS number.
Example
Dell(conf)# router bgp 3
Dell(conf-router_bgp)#
shutdown all
Disables all the BGP neighbors.
Syntax
shutdown all
Use the no shutdown all command to enable all the congured BGP neighbors.
Command Modes ROUTER BGP
Command History
Version Description
9.11.0.0 Introduced on the S-Series, Z-Series, MXL, and IOM.
Usage Information
You can use this command to disable all the congured BGP neighbors.
This command is global for all VRFs.
Border Gateway Protocol 411