Users Guide

match interface
To match routes whose next hop is on the interface specied, congure a lter.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and the interface information:
• For a 1-GigabitEthernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Related Commands
• match ip address — redistribute routes that match an IP address.
• match ip next-hop — redistribute routes that match the next-hop IP address.
244 Access Control Lists (ACL)