Users Guide
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
• Use the no permit tcp {source mask | any | host ip-address} {destination mask |
any | host
ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
bit Enter a ag or combination of bits:
• ack: acknowledgement eld
• fin: nish (no more data from the user)
• psh: push function
• rst: reset the connection
• syn: synchronize sequence numbers
• urg: urgent eld
dscp Enter the keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port parameter)
port port Enter the application layer port number. Enter two port numbers if you are using the
range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets the lter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the lter processes.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
210 Access Control Lists (ACL)