Users Guide

Version Description
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER election
if the priority value is lower than the priority value in the BACKUP virtual routers.
virtual-address
Congure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP address for the
VRRP group.
Syntax
virtual-address ip-address1 [... ip-address12]
To delete one or more virtual IP addresses, use the no virtual-address ip-address1 [... ip-
address12] command.
Parameters
ip-address1 Enter an IP address of the virtual router in dotted decimal format. The IP address must be
on the same subnet as the interface’s primary IP address.
... ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal
format. Separate the IP addresses with a space. The IP addresses must be on the same
subnet as the interface’s primary IP address.
Defaults Not congured.
Command Modes VRRP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced support for telnetting to the VRRP group IP address assigned using this
command.
1692 Virtual Router Redundancy Protocol (VRRP)