Users Guide
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
E-Series Original command.
Example
Dell# show debug
Generic IP:
IP packet debugging is on for
ManagementEthernet 1/1
Port-channel 1-2
Port-channel 5
GigabitEthernet 4/1-4/3,4/5-4/6,4/10-4/11,20
GigabitEthernet 5/1-5/3,5/5-5/6,5/10-5/11,15,17,19,21
ICMP packet debugging is on for
GigabitEthernet 5/1,5/2,5/4,5/6,5/8,5/10,5/12,5/14,5/16
Dell#
show environment
View system component status (for example, temperature or voltage).
Syntax
show environment [all | fan | pem | stack-unit unit-id | thermal-sensor ]
Parameters
all Enter the keyword all to view all components.
fan Enter the keyword fan to view information on the fans. The output of this command is
chassis-dependent.
pem Enter the keyword pem to view only information on power entry modules.
stack-unit unit-id Enter the keywords stack-unit then the unit-id to display information on a specic
stack member.
thermal-sensor Enter the keywords thermal-sensor to view information on thermal sensors.
Command Modes
• EXEC
130 Control and Monitoring