Users Guide
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2.0.0 Introduced on the Z9000, S4820T, and S4810.
Usage Information
This command provides the exibility to ne-tune the timer values based on individual interface needs when you
congure ipv6 ospf BFD in CONFIGURATION mode. Any timer values specied with this command overrides
timers set using the bfd all-neighbors command. Using the no form of this command does not disable BFD
if you congure BFD in CONFIGURATION mode.
To disable BFD on a specic interface while you congure BFD in CONFIGURATION mode, use the keyword
disable.
ipv6 ospf cost
Explicitly specify the cost of sending a packet on an interface.
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to
65535.
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
In general, the path cost is calculated as:
Open Shortest Path First (OSPFv2 and OSPFv3) 1149