Users Guide

match ra
Enable verifying either of the congured source IPv6 address or prex address or the source MAC address in the inspected messages. If
this command is not congured, the verication process is bypassed.
Syntax
match ra {ipv6-access-list name | ipv6-prefix-list name | mac-access-list name}
To reset the access list, use the no match ra{ipv6-access-list | ipv6-prefix-list | mac-
access-list}command.
Parameters
ipv6–access-list
name
Enter the keywords ipv6–access-list then the access-list name. The access-list
name allows a maximum of 140 characters.
ipv6–prex-list
name
Enter the keywords ipv6–prefix-list then the prex-list name. The prex-list name
allows a maximum of 140 characters.
ipv6–mac-access-
list name
Enter the keywords ipv6–mac-access-list then the mac-access-list name. The
mac-access-list name allows a maximum of 140 characters.
Defaults None
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Introduced on the C9010.
9.9(0.0) Introduced on the Z9500.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
Related Commands
• ipv6 nd ra-guard enable — congure the RA guard related commands.
• ipv6 nd raguard policy policy-name — dene the RA guard policy name and enter the RA guard policy
conguration mode.
mtu
Enable the verication of the congured maximum transmission unit (MTU) value in the received RA packets.
Syntax
mtu value
To reset the MTU value, use the no mtu value command.
1028 Neighbor Discovery Protocol (NDP)