Users Guide

MIB Object OID Object Values Description
• If copySourceFileType is set
to running-config or startup-
config, copySrcFileName is
not required.
copyDestFileType .1.3.6.1.4.1.6027.3.5.1.1.1.1.5
1 = Dell Networking OS file
2 = running-config
3 = startup-config
Specifies the type of file to copy
to.
• If copySourceFileType is
running-config or startup-
config, the default
copyDestFileLocation is
flash.
• If copyDestFileType is a
binary, you must specify
copyDestFileLocation and
copyDestFileName.
copyDestFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.1.6
1 = flash
2 = slot0
3 = tftp
4 = ftp
5 = scp
Specifies the location of
destination file.
• If copyDestFileLocation is
FTP or SCP, you must
specify copyServerAddress,
copyUserName, and
copyUserPassword.
copyDestFileName .1.3.6.1.4.1.6027.3.5.1.1.1.1.7 Path (if the file is not in the
default directory) and filename.
Specifies the name of
destination file.
copyServerAddress .1.3.6.1.4.1.6027.3.5.1.1.1.1.8 IP Address of the server. The IP address of the server.
• If you specify
copyServerAddress, you
must also specify
copyUserName and
copyUserPassword.
copyUserName .1.3.6.1.4.1.6027.3.5.1.1.1.1.9 Username for the server. Username for the FTP, TFTP, or
SCP server.
• If you specify
copyUserName, you must
also specify
copyUserPassword.
copyUserPassword .1.3.6.1.4.1.6027.3.5.1.1.1.1.10 Password for the server. Password for the FTP, TFTP, or
SCP server.
Copying a Configuration File
To copy a configuration file, use the following commands.
NOTE
: In UNIX, enter the snmpset command for help using the following commands. Place the f10-copy-config.mib file in the
directory from which you are executing the snmpset command or in the snmpset tool path.
1 Create an SNMP community string with read/write privileges.
CONFIGURATION mode
Simple Network Management Protocol (SNMP)
773