Administrator Guide

echo <CLI Command> | ssh admin@hostname

The SSH server transmits the terminal commands to the CLI shell and the results are displayed on the screen non-interactively.

Executing Local CLI Scripts Using an SSH Connection

You can execute CLI commands by entering a CLI script in one of the following ways:

ssh username@hostname <CLIscript.file>

cat < CLIscript.file > | ssh admin@hostname

The script is run and the actions contained in the script are performed.

Following are the points to remember, when you are trying to establish an SSH session to the device to run commands or script

files:

● There is an upper limit of 10 concurrent sessions in SSH. Therefore, you might expect a failure in executing SSH-related

scripts.

● To avoid denial of service (DoS) attacks, a rate-limit of 10 concurrent sessions per minute in SSH is devised. Therefore, you

might experience a failure in executing SSH-related scripts when multiple short SSH commands are executed.

● If you issue an interactive command in the SSH session, the behavior may not really be interactive.

● In some cases, when you use an SSH session, when certain show commands such as show tech-support produce large

volumes of output, sometimes few characters from the output display are truncated and not displayed. This may cause one

of the commands to fail for syntax error. In such cases, if you add few newline characters before the failed command, the

output displays completely.

Execution of commands on CLI over SSH does not notice the errors that have occurred while executing the command. As a

result, you cannot identify, whether a command has failed to be processed. The console output though is redirected back over

SSH.

Default Configuration

Although a version of Dell EMC Networking OS is pre-loaded onto the system, the system is not configured when you power up

the system first time (except for the default hostname, which is DellEMC). You must configure the system using the CLI.

Configuring a Host Name

The host name appears in the prompt. The default host name is DellEMC.

● Host names must start with a letter and end with a letter or digit.

● Characters within the string can be letters, digits, and hyphens.

To create a host name, use the hostname name command in Configuration mode.

DellEMC(conf)#hostname R1

R1(conf)#

Accessing the System Remotely

You can configure the system to access it remotely by Telnet or secure shell (SSH).

● The platform has a dedicated management port and a management routing table that is separate from the IP routing table.

● You can manage all Dell EMC Networking products in-band via the front-end data ports through interfaces assigned an IP

address as well.

Getting Started