Users Guide

Version Description
6.5.1.0 Introduced.
Usage Information For two MSTP switches to be within the same MSTP region, the switches must share the same region name
(including matching case).
Related Commands
• msti — map the VLAN(s) to an MST instance.
• revision — assign the revision number to the MST configuration.
protocol spanning-tree mstp
To enable and configure the multiple spanning tree group, enter MULTIPLE SPANNING TREE mode.
Syntax
protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-tree mstp command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Usage Information
MSTP is not enabled when you enter MULTIPLE SPANNING TREE mode. To enable MSTP globally on the switch,
enter the no disable command while in MULTIPLE SPANNING TREE mode.
Multiple Spanning Tree Protocol (MSTP) 995