Users Guide

Parameters
level (OPTIONAL) Enter a number for a privilege level of Dell Networking OS. The range is
from 0 to 15.
Defaults 15
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands.
To protect against unauthorized access, use the enable password command to configure a password for the
enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related Commands
• enable password — configures a password for the enable command and to access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update [interval seconds]
To disable optical power information updates, use the no enable optic-info-update interval
command.
96 Control and Monitoring