Users Guide

brief (OPTIONAL) View a summary of IPv6 interfaces.
configured (OPTIONAL) View information on all IPv6 configured interfaces.
gigabitethernet (OPTIONAL) View information for an IPv6 gigabitethernet interface.
managementethern
et slot/ port
(OPTIONAL) View information on an IPv6 Management port. Enter the slot number (0-1)
and port number zero (0).
loopback (OPTIONAL) View information for IPv6 Loopback interfaces.
port-channel (OPTIONAL) View information for IPv6 port channels.
tengigabitethernet (OPTIONAL) View information for an IPv6 tengigabitethernet interface.
stack-unit id (OPTIONAL) View information for stacking.
tunnel tunnel-id (OPTIONAL) View information for a tunnel interface.
vlan (OPTIONAL) View information for IPv6 VLANs.
Defaults None
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.11(0.0) Updated the command output to include the unicast reverse path forwarding (uRPF)
status.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.5(0.1)
Added support for IPv6 recursive DNS addresses on the Z9500.
9.2(1.0) Introduced on the Z9500.
9.2.(0.0) Added support for tunnel interface.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.2.1 Introduced on the S-Series.
8.2.1.0 Introduced on the E-Series. Added support for the managementethernet slot/
port parameter.
7.8.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The Management port is enabled by default (no shutdown). If necessary, use the ipv6 address command
to assign an IPv6 address to the Management port.
822 IPv6 Basics