Users Guide

show ipv6 flowlabel-zero
Display the flow label zero setting.
Syntax
show ipv6 flowlabel-zero
Default Disabled
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Related Commands
• ipv6 nd dad attempts — configure system to set the flow label field in the packets to zero.
show ipv6 interface
Display the status of interfaces configured for IPv6.
Syntax
show ipv6 interface interface {slot | slot/port} [brief] [configured] [stack-
unit id]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet then the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
•
For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For stacking, enter the keywords stack-unit then the stack-unit ID.
• For a tunnel interface, enter the keyword tunnel then the tunnel ID.
IPv6 Basics 821