Users Guide

ipv6 control-plane icmp error-rate-limit
Configure the maximum number of ICMP error packets per second that can be sent per second.
Syntax
ipv6 control-plane icmp error-rate-limit {1-200}
To restore the default value, use the no ipv6 control-plane icmp error-rate-limit command.
Parameters
pps Enter the maximum number of error packets generated per second. The range is from 1
to 200, where 0 disables the rate-limiting.
Default 100 pps
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
ipv6 flowlabel-zero
Configure system to set the flow label field in the packets to zero.
Syntax
ipv6 flowlabel-zero
To disable the 0 from being set in the field and allow the protocol operations to fill the field, use the no ipv6
flowlabel-zero command.
Default Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
810 IPv6 Basics