Users Guide

interface GigabitEthernet 1/2
no ip address
ipv6 address 2002:1:2::3 /96
no shutdown
ipv6 address eui64
Configure IPv6 EUI64 address configuration on the interface.
Syntax
ipv6 address {ipv6-address prefix-length} eui64
To disable IPv6 EUI64 address autoconfiguration, use the no ipv6 address {ipv6-address prefix-
length} eui64 command.
Parameters
ipv6-address
prefix-length
Enter the IPv6 prefix in the x:x:x:x::x format then the prefix length in the /x format. The
range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Introduced.
Usage Information This command allows you to create an EUI64 address based on the specified prefix and MAC address only.
Prefixes may be configured on the interface using the ipv6 nd prefix command without creating an EUI64
address.
Example
Dell(conf)# int gig 1/4
Dell(conf-if-gi-1/4)# ipv6 address 200:1::/64 eui64
Dell(conf)# int gig 1/6
Dell(conf-if-gi-1/6)# ipv6 address 801:10::/64 eui64
IPv6 Basics 809