Users Guide

• show hosts — view the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information
You can only configure one domain name with the ip domain-name command. To configure more than one
domain name, configure the ip domain-list command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
744 IPv4 Routing