Users Guide

In the event of fragmented packets, the egress port of the subsequent fragments.
NOTE: In the show port channel flow command output, the egress port for an unknown unicast,
multicast, or broadcast traffic is not displayed.
The following example shows the show port-channel-flow outgoing-port-channel number
incoming-interface interface source-mac address destination-mac address
Load-balance is configured for MAC
Load-balance is configured for IP 4-tuple/2-tuple
A non-IP payload is going out of Layer 2 LAG interface that is a member of VLAN with an IP address
Example
Dell# show port-channel-flow outgoing-port-channel 1 incoming-interface gi 3/3
source-mac 00:00:50:00:00:00 destination-mac 00:00:a0:00:00:00
Egress Port for port-channel 1, for the given flow, is Gi 13/2
Time Domain Reflectometer (TDR) Commands
TDR is useful for troubleshooting an interface that is not establishing a link; either it is flapping or not coming up at all. TDR detects open or
short conditions of copper cables on 100/1000 Base-T modules.
Important Points to Remember
The interface and port must be enabled (configured—refer to the interface command) before running TDR. An error message is
generated if you have not enabled the interface.
The interface on the far-end device must be shut down before running TDR.
Because TDR is an intrusive test on an interface that is not establishing a link, do not run TDR on an interface that is passing traffic.
When testing between two devices, do not run the test on both ends of the cable.
tdr-cable-test
Test the condition of copper cables on 100/1000 Base-T modules.
Syntax
tdr-cable-test interface
Parameters
interface Enter the keyword GigabitEthernet then the slot/port information for the 100/1000
Ethernet interface.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S4048T-ON.
9.10(0.0) Introduced on the S3148.
708 Interfaces