Users Guide

After you upgrade the system image, by entering the command. specify the location where the Dell Networking
OS image used to boot the system is stored (boot system), save the configuration to the start-up config file
(write memory), and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51.
Received block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65.
Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.......
...........!!!!!!!!!!!!!!!!!!!!!!!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Image upgraded to all
Dell#
HTTP Copy via CLI
Copy one file to another location. Dell Networking OS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP (in the hostip field).
Syntax
copy http://10.16.206.77/sample_file flash://sample_filecopy flash://
sample_file http://10.16.206.77/sample_file
You can copy from the server to the switch and vice-versa.
Parameters
copy http:
flash:
Address or name of remote host []: 10.16.206.77
Port number of the server [80]:
Source file name []: sample_file
User name to login remote host: x
Password to login remote host:
Destination file name [sample_file]:
Defaults None.
Command Modes EXEC Privilege
Command History
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.3(0.1) Introduced on the S6000, Z9000, S4810, and S4820T.
Example
copy http://admin:admin123@10.16.206.77/sample_file flash://sample_file
70 File Management