Users Guide

For more information about Port Channels, refer to the Dell Networking OS Configuration Guide.
Related Commands
• description — assign a descriptive text string to the interface.
• interface port-channel — create a Port Channel interface.
• shutdown — disable/enable the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identifies this LAG fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG number. Enter this keyword/
variable combination twice, identifying the two paired LAGs.
Defaults None
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related Commands
• port-channel failover-group — access PORT-CHANNEL FAILOVER-GROUP mode to configure a LAG failover
group.
Interfaces 699